Setting Up Focusrite Scarlett 2i2 with Pro Tools and Pink Noise Monitors

The Focusrite Scarlett 2i2 is an ideal audio interface for those looking to improve their recording setup. Designed for use with popular digital audio workstations like Pro Tools, the 2i2 can offer a seamless transition when paired with high-quality pink noise Designed for use with popular digital audio workstations like Pro Tools, the 2i2 can offer a seamless transition when paired with high-quality pink noise monitors. Read our step-by-step guide to set up the Focusrite 2i2 with Pro Tools and pink noise monitors for optimal audio results.

1. Install driver and Pro Tools software:
   First, ensure that you have installed the latest driver for your Focusrite Scarlett 2i2 from the official Focusrite website. Next, install the Pro Tools software, if you haven't already, and make sure that your licensing and registration are up to date.

   
   



2. Connect the 2i2 to your computer:
   Connect your Focusrite Scarlett 2i2 to your computer using the included USB cable. Always use a high-quality, shielded USB cable to minimize any possible interference in your audio signal.

   
   



3. Launch Pro Tools and create a new session:

   
   

After launching Pro Tools, create a new session by navigating to 'File' and then 'New Session.' In the 'Audio File Type' section, choose either 'WAV' or 'AIFF,' depending on your preference or compatibility with other software.

1. Configure Pro Tools to use the Focusrite Scarlett 2i2:
   In Pro Tools, go to 'Setup' and then 'Playback Engine.' From there, choose 'Focusrite USB ASIO' (Windows) or 'Scarlett 2i2 USB' (Mac) as your playback engine. Then, adjust the buffer size as needed. A smaller buffer size will yield lower latency but may cause audio glitches, while a larger buffer size will offer smoother audio performance at the cost of higher latency.

   
   



2. Set up your pink noise monitors:
   Connect your pink noise monitors to the audio line outputs on the back of your Focusrite Scarlett 2i2. Adjust the volume of each monitor using the input sensitivity controls on the monitor itself or in the 'Output' tab within the Focusrite Control software.

   
   



3. Configure Pro Tools input and output settings:

   
   

Once your monitors are set up, go to 'Setup' and then 'I/O' in Pro Tools. On the 'Input' tab, set your Focusrite 2i2's input channels to match the input sources you plan on recording. On the 'Output' tab, route the playback channels to your pink noise monitors.

1. Test your audio and monitoring setup:
   Finally, record a short audio clip in Pro Tools to test your setup. Ensure that your audio is coming through clearly and that the pink noise monitors are functioning correctly.

By following these steps and ensuring all connections and configurations are properly set, you'll be well on your way to enjoying high-quality audio recordings with your Focusrite Scarlett 2i2 and Pro Tools setup.